Simviation Forums

Love the new Duke!  One odd thing, I have the normal views I use the most set on my CH Yoke buttons.  The outside view, the 2-D (which I usually save flights to, but don't fly with) and the VC.  Don't miss the 2-D at all, but when I press the VC button, I get a view from the rear of the cabin and have to hit 'A' twice (cycling through 2-D and then VC) to get to the VC left cockpit view that I want.  Is there a way to have the view I need come first?

That's odd, it starts with the normal view for me.

Maybe your standard flight when you load FSX does not have the initial VC view, and the settings are transferred to the Duke, when you select it.

I would try saving a flight as standard with the initial VC view selected.

It does load in the normal VC view, but if I switch to the outside view and then back to the VC I find myself in the right hand rear seat looking out of the window.  I'll click 'A' once and I'm where the 2-D would be, click 'A' again, I'm in the left hand VC pilot's seat where I want to be.  
I looked at the aircraft.config file and it is obviously beginning with 07, then cycling to the 2-D which is not defined, and then the VC left seat which is also not defined, then it begins the defined cycles beginning with 00 which is the right seat, etc.
It's not a big deal, just two more button pushes I usually don't have to make to get back in the cockpit. I climb outside to take pictures a lot.  8-)

Let me add, I wouldn't mind a fix if anyone has any ideas.

Fixed!  I downloaded the new Real Air Duke SP1 yesterday, and now I can get to the pilots view VC by pushing the button I had assigned to it in FSX.  Of course the SP1 has much more including the ability to add the GNS530 & 430 from RXP (if you have purchased them) to your Duke panel.  A fantastic aircraft has been made even better!