Simviation Forums

hy

i use this 747 of overland in fs9 but i always get this when i load my airplane

after it "crashes" and reloads, does it 'crash' again like there is no nose wheel????

looks like the designer might not have the nose wheel 'contact point(s)' set properly, like it is too high from the ground and the nose flops down breaking the strut and BAM!!!! there goes the nose. (or there is no contact point at all.)

1 suggestion that i might be able to give you, is find another 747 and put THAT texture on it and see if that will work for what you want to accomplish. if that wont work for you, then 'I' personally am not sure how to fix that problem as i have not built any planes...... only reworked a few FS9 panels.

i entered the contact points of the default 747 in the cfg of the overland 747 it solves my problem +- (the wheels sink away for only a few cm)