Hi there,
I just realized that even though the altimeter displays both in/hPa and in/Hg values, if I set it, only the in/Hg is changing. I think these should be synchronized. I was under the impression that it was always like that, but today I just realized, that I cannot set the QNH value in in/hPa for some reasons at all. Anyone else has similar issues or there's a good solution for that? On Level-D 767 it just works fine.
Ohh btw...I know that theoretically it can be set on the EFIS panel's relevant button, but it's just not working...if I rotate it, it's setting the value, and not the switch between the unit systems.
Greetings, neu