Shockwave P-40
Posted:
Sat Oct 13, 2007 7:39 pmby Ravang
I just got this beautiful aircraft, and when I went to fly it my scenery would not load into a higher res. (it was very fuzzy, and so were the building textures), even though I have my scenery sliders on mid settings :-/ I think I might need more RAM (specs under sig), anyone else have this problem :-?
Re: Shockwave P-40
Posted:
Sun Oct 14, 2007 11:46 pmby Souichiro
Ram might be usefull! Try this though the next time... Hit the esc key (escape) and You'll get the menu asking you if you want to quit the flight... which you don't.. so then press it again.. and sometimes it'll load your textures completely
Hope it works!
Re: Shockwave P-40
Posted:
Mon Oct 15, 2007 9:41 amby Ravang
I think I found my problem I have just updated my video drivers and it messed up FSX, so I rolled back the drivers and it work fine now
Re: Shockwave P-40
Posted:
Mon Oct 15, 2007 10:11 amby mrjake2002
I think I found my problem I have just updated my video drivers and it messed up FSX, so I rolled back the drivers and it work fine now
That happened to me too (only with FS9) :)
Re: Shockwave P-40
Posted:
Wed Oct 17, 2007 5:45 amby Mees
Or go into your Controls>Assignments menu and find the command 'Refresh Scenery', that's pretty useful too 8-)