Simviation Forums

Hiya,

I purchased the 737-300/400/500 from 50 north.

www.fiftynorth.com

I have tried to contact them. via e-mail + have had NO reply on numerous occasions.

Basically when will the wingviews be released because the website has not been updated for ages?

Also why is it not possible just to type wingview commands into the pane.cfg?

Thanks,
Richard!

Hey
I dont have the 50N 737s but I am sure if you searched it on google or better avsim, you would find something.

The 50N 737 doesn't have a panel, VC or cabin yet.

It's shown in the coming soon page: "2D Cockpit, VC + Cabin"

The exterior model is good but the panel and VC really needs to be put in this aircraft and they've been at it for a while but I have not heard one bit of news about it.

I bought it as I was looking for a good old gen 737. What a waste of my hard earned cash. :-/

Cheers
Cameron

I bought it as I was looking for a good old gen 737. What a waste of my hard earned cash. :-/

Cheers
Cameron

I didn't think it was a waste of hard earned cash. Flight1 already warned you that the product was a model only. For $15, I don't think it's that bad. Pretty detailed exterior....and for existing customer's the update for the VC and cabin will be free...I'm not complaining...makes for very photogenic shots...