Sigma/DSB Harrier

[oscarfourzero]

Hello,

        I have a problem with the Harrier when i start to taxi after landing , it starts to bounce and jump about and disappears under the runway and back up and then goes all over the place , at which stage i have to stop the sim , i have tried other airports and took out the fuel but it makes no differance,

         I have never had an aircraft do this before and other than this it fly's great ,


         Any help would be appreciated,

         Thanks,

          Roger.

[Mike63]

Do you put the nozzles in the trail or aft position after landing, or taxiing? Vertical nozzles may be a cause -

Semper Fi

Mike

[oscarfourzero]

Hello Mike,

             Well perhaps its me , i land at about 30mph full flaps and the nozzle at 45 degrees and retract it all staight away once on the runway but it starts jumping before it stops.


             When i start on the runway i have tried with the settings the same [full flaps 45 etc ] and taxi all around and it seems fine , it just seems to happen when landing, Very strange!,

              Thanks,

               Roger.

                       

[oscarfourzero]

Hello Mike,