Autoland gauge not showing up in Vista

[MrHaroldG2000]

Recently I transferred my FS2002 from an XP computer onto a Vista and set it run in compatibility mode for Service Pack 1. I clicked on to "Run as Administrator," but the Autoland gauge that was installed on some of my aircraft didn't show up. I wonder how can I get the Autoland features to show up (uninstall and re-install, etc.)?

[microlight]

If it's the gauge from the downloads section here then it was designed for FS9 and is untested in FSX. As the gauge author (me) doesn't have FSX, there's not a lot can be done...

[MrHaroldG2000]

If it's the gauge from the downloads section here then it was designed for FS9 and is untested in FSX.

I had the gauge for FS2002

[microlight]

Apologies - I should have said that I use XP not Vista, so unfortunately can't help out there either.

[H]

There is an autoland_2000.zip which might work in 2k2 (was made for FS98 and 2k).
There is the autoland_v1.zip listed for FS9 and 2k2  in the FS2004 section.

Which do you refer to?

8-)

[MrHaroldG2000]

Sorry for not responding earlier, but since the most recent post I found a way to work around the problem - I simply set FS2002 to "Run as Administrator"