Page 1 of 1
cabins & cockpits
Posted:
Sun Jan 08, 2006 5:39 pmby captjim
Hi fellow simmers, captjim here again. My question this time concerns views of cabins and cockpits. I know that I can use the numbers pad to look around, however I have not been able to get some of the real nice views of the cabins & cockpits that are indicated in the aircraft listed in the site-map. Is there anything I can do to improve these views????? Thanks, again captjim
Re: cabins & cockpits
Posted:
Sun Jan 08, 2006 5:51 pmby elite marksman
You have to be in the virtual cockpit and use your joystick's hat ( little but usually by your thumb on the middle of the joystick that can be pushed in 8 different ways). Or you can get F1 veiw. But I have no idea how that works.
Re: cabins & cockpits
Posted:
Sun Jan 08, 2006 5:57 pmby Hagar
If I remember correctly the default key commands for moving around the DVC are Shift+Backspace/Enter & Ctrl+Backspace/Enter. You can play around with them or try F1View as Marksman suggested. I haven't tried it myself & assume it's posted in the Utilities section here at Simviation.
PS. F1View is for FS9. I'm not sure it will work in FS2002.
http://www.flight1.com/view.asp?page=library
Re: cabins & cockpits
Posted:
Sun Jan 08, 2006 6:20 pmby captjim
Thanks again, for the rapid response. You guys rock. captjim
Re: cabins & cockpits
Posted:
Mon Jan 09, 2006 2:16 amby africancapt
Hai Guys,
I am relatively new to this forum, but i have been flying (SIM) for close to 2000 hours. I downloaded the A319 Airbus easy jet, when i load the plane it does not display the gauges and all buttons that relate to autopilot, what could be the problem?
Re: cabins & cockpits
Posted:
Mon Jan 09, 2006 5:08 amby ozzy72
Hi Africancapt, it sounds like you haven't put the gauges in the FS2002/gauges folder. Just follow this excellent tutorial by our very own webmaster and you'll be fine
http://www.simviation.com/acinstall.htm
Re: cabins & cockpits
Posted:
Mon Jan 09, 2006 7:59 amby Mehdi
Or you can get F1 veiw. But I have no idea how that works.
The original version of Active Camera for FS8 was free and is still available at various sites.
Re: cabins & cockpits
Posted:
Mon Jan 09, 2006 7:52 pmby Apex
CaptJim: You can also move forwards and backwards in the VC: Forwards the '=' key, backwards the '-'. But check the assignments to be sure I've got the right keys; I've reassigned everything and cannot be certain these are the default assignments: Main menu>Settings>Assignments:
Forward is "Increase selection slightly", backwards is "Decrease selection slightly".