Page 1 of 1
Low Speed elevator/trim power
Posted:
Fri Nov 19, 2004 2:24 pmby RAFAIR100
At low speeds, a number of my downloaded aircraft run out of elevator power and elevator trim power. I have set both effectiveness parameters to max in FS Edit without much appreciable effect. Can anyone suggest which parameters to 'tweak' in FS Edit or in the .AIR file to get round this problem?
Re: Low Speed elevator/trim power
Posted:
Fri Nov 19, 2004 7:34 pmby chomp_rock
What aircraft does this problem occur in?
Re: Low Speed elevator/trim power
Posted:
Sat Nov 20, 2004 6:31 amby papa-metro
in the aircraft.cfg file ... open it w/notepad and check elevator_trim effectiveness=
It's usuall set at 1.0 try a (slightly) larger # ie 1.5 and adjust the effect from there.
Papa-metro usaf 1953-57
Re: Low Speed elevator/trim power
Posted:
Sat Nov 20, 2004 8:28 amby RAFAIR100
Problem occurs on quite a few downloaded aircraft - the Barracuda is just one example