Simviation Forums

Hello friends!

I dont know if this is the right place to post this forum but any hellp will be deeply appreciated

I just installed ch flightsim yoke and rudder pedals
My problem consists that when I fly a cessna 182 (for example) and I want to reduce the mixture it doesnt work;  prop lever works as a rudder  (I think)

When I try to assign this levers, the instructions say to press a button,  but guess what...its a lever, so i can assign it

Please, can some one please help me how to configure this yoke.

Thanks

Juan Carlos

Hi Juan Carlos,
'You can get help at the Ch products forum site.
Here is their web site  http://www.ch-hangar.com/forum/index.php?act=idx

Good Luck,

Chief

these assignments are under axis catagory in your set up dialog...

Like exit said, look near the top of the key assignment page.  There should be two tabs.  The one that says axis is the one you want.