ch flight sim yoke assigments

[juanca]

Hello friends!

I dont know if this is the right place to post this forum but any hellp will be deeply appreciated

I just installed ch flightsim yoke and rudder pedals
My problem consists that when I fly a cessna 182 (for example) and I want to reduce the mixture it doesnt work;  prop lever works as a rudder  (I think)

When I try to assign this levers, the instructions say to press a button,  but guess what...its a lever, so i can assign it

Please, can some one please help me how to configure this yoke.

Thanks

Juan Carlos

[chief1995]

Hi Juan Carlos,
'You can get help at the Ch products forum site.
Here is their web site  http://www.ch-hangar.com/forum/index.php?act=idx

Good Luck,

Chief

[exit]

these assignments are under axis catagory in your set up dialog...

[Travis]

Like exit said, look near the top of the key assignment page.  There should be two tabs.  The one that says axis is the one you want.