Simviation Forums

Hi,

I have trouble with Mr. Swordy's TTools 1.33, I did everything in the aircraft.txt and flightplans,txt and complied it. But the AI plane that was suppose to be at the airport never showed up.The time was right and that plane is an AI plane. Can anyone tell me the whole procedure of adding AI aircraft for 1.33 ? I would most appreciate it.Thank you.

PSW

Best you go and look in the AFCAD and TTools forum where all this stuff is covered and discussed in detail. Read back over a few weeks worth of posts - you'll learn everything you need to know about AI traffic. Then if you still have a problem, which I doubt, come back and ask again.

It's just that your query is so general that you really do need to look at how other people have approached similar problems

Hi,

I use traffic tools 1.33 very often so far I've created hundreds of connections and TT works perfectly - almost

I'm saying almost because they are certain conditions that i.e. your aircraft will not show up at the right time and right place at the airport field.

My advise is:

1. You must read !! TT manual - it's very important why ? because you will find there all information describing in which conditions you will not see your aircrafts.

2. Be very careful while typing new traffic - I had it few times - you make v. small mitsake and all goes wrong