Simviation Forums

I have activated the autopilot in cfg of an add on aircraft and it works.  However there is no autopilot functions showing on the stack.  Can this be done so I can see what is active or not?  Also, GPS is there but again no switch shows.  :o

You have to add the switches to the panel or you won't see them. Go into the panel folder and open panel.cfg, and then add them, the two numbers after the button are its x and y co-ordinates on the panel.

Ozzy

Ozzy, is there a tutorial for that lying around somewhere? I would love to check it out.

Go here

http://zone.msn.com/flightsim/FS02DevDeskSDK00.asp

and get the panels and gauges SDK.