Simviation Forums

Hi there,
I have just purchased ultimate traffic from flightone. It is really spectacular. I only have one question and the answer probably has something to do with TTools and I'm not very familiar with that, but I'll ask anyway.

The traffic at major airports has obviously increased dramatically (new liveries, etc.), only problem is since I have been flying with it installed, my general aviation traffic has all but vanished, especially at my home base, which is a small but busy GA airport. How can I increase it back to where it was with the default FS traffic at 100% over even increase it more than that. It seems that 'Ultimate Traffic' has turned my big airports from ghost towns to very busy spots but inturn it has turned my small GA airports from busy spots to ghost towns.
Any suggestions would be much appreciated
Eric

Have you tried adjusting the settings for AI traffic in FS2k2 itself? Try maxing the slider and see if that helps.

Ozzy

Thanks for the reply Ozzy. I have my slider at 100%, always have. I went onto the 'Ultimate Traffic' official website and read some of the comments in the forums there and noticed some people asking the same questions. Unfortunetly, there were no responses to there questions!
I'll keep playing around, I guess?
Eric

I might be wrong but isn't the Flight One addon an extension of PAI? They concentrated on airliners & the heavies. It's possible some, if not all, the GA aircraft have been replaced with these types. I would think the best way to find out & get support is to contact Flight One.

Sorry disregard this post. It's working fine now. I must add what an amazing program. If anyone out there enjoys lots of traffic, it rocks!
Thanks for the replies
Eric