Page 1 of 1
B737-400 turning problem

Posted:
Fri May 30, 2003 7:02 am
by Copilot
I'm having a problem with the B737-400. As soon as I take off, it automatically turns to the right and keeps turning. Pressing Num 5 has become useless. I should press Num 4 to prevent turning to the right and keep it on track.
Regards
Re: B737-400 turning problem

Posted:
Fri May 30, 2003 7:04 am
by liran_bar
Hello copilot and welcome to simV.
Is this the deafult 737 or a downloaded one?
Liran Bar, Israel
Re: B737-400 turning problem

Posted:
Fri May 30, 2003 7:22 am
by liran_bar
One more thing that can cause this problem:
Are you sure your fule is balanced? meaning, do you have the same amount of fuel in both left and right tanks?
Liran Bar, Israel
Re: B737-400 turning problem

Posted:
Fri May 30, 2003 7:27 am
by Hagar
On multi-engined types make sure all your engines are running before attempting to take off. Also that your controller is set up for all throttles. (Hit E then 1, 2, 3 & 4 in quick succession. Keyboard, not Number Pad.)
Re: B737-400 turning problem

Posted:
Fri May 30, 2003 8:43 am
by JBaymore
Also...on multi engine jets it seems that you can get asymetrical thrust out of the engines on some aircraft if you don't give the engines a bit of a "spin up" to about 40+ percent or so for a couple of seconds before you bring them up to takeoff setting. If you just go from idle to full throttle sometimes the plane "pulls" to one side.
best,
.......................john
Re: B737-400 turning problem

Posted:
Fri May 30, 2003 8:45 am
by JBaymore
Oh yeah....... forgot.........
Are you taking off in a cross wind ;) .
Or is the rudder trim control set centered?
best,
.............john
Re: B737-400 turning problem

Posted:
Sat May 31, 2003 12:37 am
by Erhan
is autopilot on

Re: B737-400 turning problem

Posted:
Sat May 31, 2003 10:28 am
by Copilot
Thanks alot every one, my problem has been resolved.
Thanks Liran Bar, actually, there was no fuel at all in the left tank, all values were set to (0).
I CAN FLY SAFELY NOW!
Re: B737-400 turning problem

Posted:
Sun Jun 01, 2003 3:23 am
by Erhan
lol