Page 1 of 1
Make it stop!!!!
Posted:
Wed Apr 30, 2003 2:23 amby MattNW
I have the Fleet Canuck that I downloaded here at Simviation. Whenever I fly it I get a continous morse code identifier that doesn't stop. I've tried changing frequencies and the keyboard shortcuts to turn off all identifiers but nothing stops it. It's a nice plane but that noise for an hour without stop drives me crazy. The only way I can stop it is to turn off power to all avionics equipment. That stops it but it also leaves me without any avionics.
Re: Make it stop!!!!
Posted:
Wed Apr 30, 2003 2:29 amby Smoke2much
If you go into the settings/sounds you can adjust all of your volumes. Either turn the engine noise up or the navigational aids noise sounds down.
Will
Re: Make it stop!!!!
Posted:
Wed Apr 30, 2003 9:24 amby BE58D
Or make sure that none of IDENTs are turned on for the NAV1, NAV2, ADF or the MARKER BEACONS. This is found on the audio panel, usually above the radio stack.
Re: Make it stop!!!!
Posted:
Wed Apr 30, 2003 5:32 pmby MattNW
I've turned the idents off, or at least tried to. It seems to be limited to only the one aircraft, Fleet Canuck 80 Floats. When I switch to another aircraft the sound stops but when I switch back it's there again. It also seems to be one of two different identifiers either
"- - - . - . - . ." or ". - . ."
wich doesn't change no matter where I am or how far I fly I never seem to get out of range. It has to be a quirk with the configuration file or something. I guess on this aircraft I'll have to do without auditory idents and double check my navigation frequency settings.
I like the plane but for this one little quirk.
Re: Make it stop!!!!
Posted:
Wed Apr 30, 2003 5:49 pmby phil509
Success!!
Posted:
Wed Apr 30, 2003 8:19 pmby MattNW
Well, I just kicked the sucker out to walk at 5000 AGL. Don't know what I really did but I compared the Canuck .cfg file to the Lake Renegade file and the section on radios had one difference. I changed:
"Audio.1=0"
to:
"Audio.1=1"
and I don't have the noise any more.
Now does anyone know what the heck I did? ???
Re: Make it stop!!!!
Posted:
Wed Apr 30, 2003 8:57 pmby Imzzaudae
- - - = O .-. =R -.. =D ORD
Chichago 113.9
Take another look at the ident buttins eather nav one
or 2 ident is on.
Best of luck
Re: Success!!
Posted:
Wed Apr 30, 2003 9:49 pmby FSTipster
[quote]
Well, I just kicked the sucker out to walk at 5000 AGL. Don't know what I really did but I compared the Canuck .cfg file to the Lake Renegade file and the section on radios had one difference. I changed:
"Audio.1=0"
to:
"Audio.1=1"
and I don't have the noise any more.
Now does anyone know what the heck I did?
Re: Success!!
Posted:
Thu May 01, 2003 1:44 amby MattNW
[quote]
Enabled the audio panel in the aircraft, despite the fact that
Its a classic GREMLIN 