Page 1 of 1
Afcad and ATC
Posted:
Wed Mar 12, 2003 4:51 pmby Johnathon
I've downloaded some scenery for schipol airport(the new runway) and done the afcad file so AI would use the new runway but ATC tell me to taxi to runway 1 right and can't understand why because it's an overlay of the airport and all runways exept 36L for takeoff are closed . Does anyone know why this is happening?
thanks
Re: Afcad and ATC
Posted:
Thu Mar 13, 2003 10:35 amby ozzy72
Johnathon, the default runway can't be changed. All the afcad stuff does is to allow AI to use bits like gates etc. Unfortunately this is preset, maybe in ACOF it will be fixed.
Ozzy
Re: Afcad and ATC
Posted:
Thu Mar 13, 2003 12:42 pmby Johnathon
But in afcad 1.3 you can close runways like I did but they still want me to use runway 1R to takeoff.
I even tried deleting all other runways but still the same and the airport overlay name is 2HAM which only has seven parking spots .
The parking spots arn't even connected to EHAM so I don't understand.
I've created other overlays and they work fine using the runways that I want them to use ::)
Thanks for replying anyway