Display Problems after using Active Camera Pro...

[Cherokee_6]

Hello All,

Last night I took my Baron out for a flight over the Rocky Mountains and I tried using Active Camera Pro to view the plane from the wing tip.
Well after that whenever I tried to do a view from the Chase View all the colors were smugging together...

It seemed to be working fine before I tried using active camera pro to look around while in flight.

I have a Nvedia GeForce2 64 meg video card and my display settings were set to 1024x768 x32.

I just upgraded my video drivers so that I could run FS2002 in 1024X768 size. Before I had to keep it at 800x600 if otherwise I could not get my ALT menu to appear during a flight.

Anyone have any ideas or any tests I can run on my video card to make sure its running ok???

Thanks

[Cherokee_6]

BTW...the drivers that I updated to where version 41.09.

(If that helps...)

Thanks

[Fly2e]

Hey Cherokee,

I have seen this before with my old PC. I do not know what it is. I have an Active Camera question. I have the same version and when I want to "walk around the plane or around the outside", the view puts me under the aircraft and thats it. I have a wheel on my mouse and my system has more than enough power to handle this little add-on! I have read the Active Camera "Notepad" and followed the directions for this but can't walk around the plane. The wheel works for zooming and fly-bye works. Any suggestions? Thanks

[GreG]

Mate, it's a memory problem as far as I know, I get it all the time, that's why I never use the external pilot's view, or it's a serious bug in the active camera module.