baldomero wrote:I want to flight from A to VOR of B following a radial (TO or FROM the VOR it's not here the matter). I enter the freq. of VOR in NAV and in AP NAV and the ALT said by ATC. Set AP and put OFF. I start flying and obviously I'm not in the radial desired. Here are two possibilities:
a) I put on VOR1 the radial I desire and in HDI I change my bearing to intersect the radial and to get the needle centered and THEN, and just THEN I put the automatic pilot.
or b) I activate the AP (with NAV active) and leave that AP make all the word of changing bearing in order to get the needle centered (= intersect the radial and follow it).
What should be done? Thank you.
Staiduk wrote:Well; this is many months old; but my suggestion would be this:
TURN OFF THE FREAKIN' AUTOPILOT ALREADY!!!!
You want to learn to fly? OK then - LEARN TO FLY.
The Autopilot is there for experienced pilots to reduce their workload in the cockpit. Nothing more. If you haven't the skills to navigate a craft from A to B without the autopilot; you have no business being behind the yoke. That's the benefit of MFS; you have the opportunity to train without complication.
Learn how to fly FIRST. THEN learn how to use the autopilot. Your skills will thank you.
Fozzer wrote:Staiduk wrote:All you need is something like "Plan-G*", or "FS Tramp**" maps, which list all the Radio Nav Frequencies in your location/area, to dial into your Radio!
...and the Flight Simulators handle it so well...I reckon!
PhantomTweak wrote:Absolutely agree with you! Having said that, even the 172 has an autopilot. Me, I just keep the AP in most planes for the yaw Damper effect, other than that I don't use it on any aircraft.
Just me, that's all
Users browsing this forum: No registered users and 100 guests