Simviation Forums

I just downloaded the Simtech Beechcraft C45G N7826L. What is the trick to getting the engines running. They will turn over with the starter but will not keep running. Fuel is on and mags are set to both. Throttles, props and mixture are all up.

Thanks
DickA

Well I start my FSX with engines running and this engine runs fine .. . But if you shut down this I also see it doesn't just restart with CtrlE.

Here is the start procedure from the original manual: (didn't try a restart)

[quote]Manual Engine Start:

If you prefer not to use CTRL-E to auto-start your engines, here

No problems with the engines but it's caused all my aircrafts ailerones to go on full deflection, banking right!

Lifes too short. Deleteing.

Zaphod

Unlikely to be this plane. If it was the case it would have done that to mine too .. and it hasn't.


Calibration comes to mind .....

You may well be right Pete, but I had no probs before checking it out and I have no probs after deleteing?

Zaphod.

Reply to Zaphod.
Not only do I have the engine starting isuue but it also caused all my ailerons to go to a full right bank also. Not just this plane but all my FSX planes. I shut down and restarted FSX and it cleared it up. Not sure if it will do it again.

DickA

Downloaded the D-Day version and had the same aileron problem. Further investigation showed that the problem was caused by my default flight which was saved with the auto pilot activated. Turning the a/p off has sorted that out.
My Bad.

Zaphod