Page 1 of 1

Stranger Still....

PostPosted: Tue Jun 05, 2012 8:12 am
by Flying Trucker
Good morning all... :)

This post is with regards to a previous post of mine, same section....Ant's Tiger Moth...

Well I just notice this and not sure how to fix it.

I do not have my MAXX Control Yoke and Rudder Pedals anymore.

Re: Stranger Still....

PostPosted: Tue Jun 05, 2012 8:46 am
by todayshorse
http://www.logitech.com/en-gb/gaming/joysticks/302

Dave from Barnsley :-

"the biggest flaw of all is that you cannont twist it to control the rudder , this effectively makes it useless !"

Hmmmm  :)

I use an old logitech 'wingman' - which does allow you to twist it. And its got force-feedback that makes that much noise it  scares the cat. Next doors cat.

Id like somthing a lot better though.

But one question? How did you taxi about?  ;)

Re: Stranger Still....

PostPosted: Tue Jun 05, 2012 10:04 am
by Bass
I have no problems on my old ms force feed back, it has a rolling stick. Just tested it.
But i use Hotas cougar and that is another case. I need to set the rolling/rudder on ant elev, and that one, is not easy to control at 200 mph.

Re: Stranger Still....

PostPosted: Tue Jun 05, 2012 12:12 pm
by Flying Trucker
Hi "todayshorse"

The aircraft will all taxi OK, it is I just can't see any Rudder movement and that just seems odd.  Not sure how long this has been going on because at one time I could see rudder movement.

Re: Stranger Still....

PostPosted: Tue Jun 05, 2012 12:41 pm
by Hagar
In the Realism Section of FSX I have Autorudder checked.

That is the cause of your problem. As your joystick has no rudder control you will have to use the keyboard rudder commands or assign buttons to them

Re: Stranger Still....

PostPosted: Tue Jun 05, 2012 2:24 pm
by Daube
In the Realism Section of FSX I have Autorudder checked.

Problem spotted, indeed ! Excellent eyes Hagar, as always.  8-) I didn't see that sentence and I was still looking for a solution. I should stop reading so fast  :-[

Re: Stranger Still....

PostPosted: Tue Jun 05, 2012 6:05 pm
by Flying Trucker
Thanks again Doug and Stephane...do not recall that problem but if that is it...then that is it... :)