Page 1 of 1
Accelleration VC problem after re-install

Posted:
Fri Aug 13, 2010 6:06 pm
by Rudderbutt
After re-installing windows xp home (32) I re-installed FSX then Acceleration. I find that the glass gauges in the F-18 and the Augusta Westland do not display at all.
The glass cockpit Mooney and Cessna that are part of the original Deluxe FSX are fine.
Any ideas?
Thanks all....
Rudderbutt
Re: Accelleration VC problem after re-install

Posted:
Sat Aug 14, 2010 3:05 am
by mjrhealth
Did you run fsx before installing accleration. it seems to be part of the requirement for fsx to set it self up properly. Ie install fsx. do a short flight, exit then insatll acceration, which will install sp1 and 2 in its process.
Re: Accelleration VC problem after re-install

Posted:
Sat Aug 14, 2010 1:10 pm
by Rudderbutt
I'm not sure if I did nor not...
I guess I should just uninstall everything and do just that.
Thanks
Re: Accelleration VC problem after re-install

Posted:
Sun Aug 15, 2010 5:18 pm
by Rudderbutt
I just finished uninstalling and re-installing FSX and then Acceleration (after a few flights in FSX per mjrhealth's suggestion.)
the problem persists. no gauges in the F-18 or Augusta chopper.
When I uninstalled, I left the save flights, etc., folders intact.
Maybe I should do it again and not save those.
Any ideas?
Thanks
Re: Accelleration VC problem after re-install

Posted:
Sun Aug 15, 2010 6:21 pm
by Knick
I just finished uninstalling and re-installing FSX and then Acceleration (after a few flights in FSX per mjrhealth's suggestion.)
the problem persists. no gauges in the F-18 or Augusta chopper.
When I uninstalled, I left the save flights, etc., folders intact.
Maybe I should do it again and not save those.
Any ideas?
Thanks
Yes clean install, delete everything that is left over.
Re: Accelleration VC problem after re-install

Posted:
Tue Aug 17, 2010 4:52 pm
by Rudderbutt
still no go.
I did a completely clean new install ran MSX then installed Acceleration, and still not guages in the F-18 Or Augusta chopper.
I'm at a loss.
Any ideas??
Thanks,
Re: Accelleration VC problem after re-install

Posted:
Tue Aug 17, 2010 5:23 pm
by Knick
still no go.
I did a completely clean new install ran MSX then installed Acceleration, and still not guages in the F-18 Or Augusta chopper.
I'm at a loss.
Any ideas??
Thanks,
Try a repair.
Re: Accelleration VC problem after re-install

Posted:
Wed Aug 18, 2010 2:33 am
by Daube
You said you reinstalled XP.
Did you update the various libraries, like .NET Framework and C++ Runtimes ?
Re: Accelleration VC problem after re-install

Posted:
Thu Aug 19, 2010 12:43 am
by Rudderbutt
I believe I did update .NET Framework. I recall having some errors or something and having to update that. I'm not sure about C++runtimes.