Page 1 of 1
How do I get into the VC??
Posted:
Tue Aug 10, 2010 12:08 pmby Solid
Hi...
I would like to modify a VC from a freeware model, can someone tell me which file must I access and if a need a special program or tool...
Thanks
Re: How do I get into the VC??
Posted:
Tue Aug 10, 2010 12:36 pmby Daube
The position of the 2D gauges and 2D switches in the virtual cockpit are defined in the [VCockpit*] parts of the panel.cfg of the plane. It works exactely like 2D panels: name of the gauge, X, Y, lentgh, height...
You cannot modify the 3D gauges or 3D switches, because they are part of the 3D model of the cockpit.
Re: How do I get into the VC??
Posted:
Tue Aug 10, 2010 12:38 pmby Boikat
If I'm not mistaken, the VC is part of the model, and without the source code, and the appropriate 3D modeling software, you cannot modify the VC, except maybe the guages.
Re: How do I get into the VC??
Posted:
Tue Aug 10, 2010 1:45 pmby BrandonF
Yep. The VC is part of the model. You CANNOT change anything except the 2D gauges without the original source files.
8-)
Re: How do I get into the VC??
Posted:
Tue Aug 10, 2010 2:21 pmby pete
Hi...
I would like to modify a VC from a freeware model, can someone tell me which file must I access and if a need a special program or tool...
Thanks
What is it you want to do?
You can change or update gauges using FS Panel Studio.
Re: How do I get into the VC??
Posted:
Tue Aug 10, 2010 2:35 pmby Solid
Hi...
I would like to modify a VC from a freeware model, can someone tell me which file must I access and if a need a special program or tool...
Thanks
What is it you want to do?
You can change or update gauges using FS Panel Studio.
Thanks guys....Yes I want to beef up a panel with some gauges. I know I will not be able to do anything with the 3D stuff. I do have FS Panel Studio but have not used it in many moons, will try tonight......Thanks again.
Gera....