Simviation Forums

Hi i have reccently purchased Acceleration and the first thing i wanted to do was the carrier ops, i get throught the first bit no problem but when it comes to the launch bar i can lower it, it is just when i apply full throttle it comes off and i end up in the water! what am i doing wrong?

(i dont have Accelleration) but is there a button or gauge inside your aircraft to tell the CATapult how much force to use to launch you off the deck?

There's a key to trigger the launch. Take a look through the button assignments to find it, its been ages since I've reset it so I don't remember the default.

There's a key to trigger the launch. Take a look through the button assignments to find it, its been ages since I've reset it so I don't remember the default.

yep and you have to be  on a carrier and attatch to the launch thingy thing too.
Do the tutorial accel comes with and you will learn a good bit.

I have done the tutorial for taking off on the carrier and landing part it is just when I want to take off I put the launch  bar down but as soon as I pit full throttle on the launch bar comes of!!!

Shift U - lower launch bar
Shift I - arm catapault ( should stop plane moving when throttle increased )
Shift Space - Launch

Note the plane must be in correct position on launch pad for it to arm, so if rear deflector doesnt come up, then move plane a lttle and try again. Its not as simple as putting the front wheel in the box.

Oh i see now i had to press Shift+I !!
i had no clue, the tutorial didnt say, thanks alot man!