Simviation Forums

I have the POSKY BBJ2. I followed this tutorial (http://forums.overclockers.co.uk/showth ... t=17996209) which I have used flawlessly before. I tried to use the default 737 VC with the BBJ2 and this is what I get:


It's like this on the tail too.

Any ideas on what is wrong?

Thanks for any help.

8-)

Im not sure it is possible with the BBJ as it is not an FSX SDK model, but you could try using the textures from the BBJ on the 737-700 from posky where there is a fsx SDK available

The BBJ2 is a 737-800. I tried to use the POSKY 737-800 model update for FSX with it. Is this the problem?

[edit]I may have used the wrong model, I'll have to check.[/edit]


[edit]Yup, just had the wrong model. Switched it out and it's working now. Thanks.[/edit]

8-)

np

Well the BBJ2 model that POSKY put out is the most recent addition to the 737 line and was only compiled using the FS9 SDK. So in essence you downloaded the wrong FSX model update because there is none for the BBJ2

FS9 or Bust

Well the BBJ2 model that POSKY put out is the most recent addition to the 737 line and was only compiled using the FS9 SDK. So in essence you downloaded the wrong FSX model update because there is none for the BBJ2

FS9 or Bust

It uses the bottom model:

http://www.projectopensky.com/downloads ... delpackage



8-)

But when you use that model you lose the antennae on top of the plane yeah the main parts (fuse, wings etc) are the same but there are minor details that are updated with the original FS9 BBJ2 model