Simviation Forums

Hi all a little trouble here. I have downloaded the file FS2004/FSX Piper Super Cub PA18_V3 Package from http://www.simviation.com/simviation/?t ... =61&page=3. Also 2 other files, a patch and a panel fix. I have installed the lot, but when I start FSX I get the following message:

There are multiple objects with the same title name. They must have unique tile names.

Super Cub PA18 N4188Z
Sim Objects\Airplanes\Piperpa18a

I'm not sure what I need to change to get both of the a\c flying. I can get the standard version flying but the Tundra wheeled version doesn't show up in the a\c list. Any help would be appreciated. Thx

BF

This is usually caused by duplicate Aircraft.cfg entries. Make sure all variations of the aircraft have different title= names.

Thx for the response. I went in and  looked...and yep you had it right the cfg file was the same. So i went back and looked again at the instructions  with a non tired head and the "fix" was for the standard version only. I had applied the cfg file fix to both. So now Im happily tooling around in a great little cub. Thanks again.

BF