hHancer, driver or procedure?
Posted: Mon Jun 22, 2009 11:44 pmI was running Vista 32, nHancer 2.32 and Nvidia 8800 GTX pretty well. Today I installed a new Nvidia 285 GTX expecting at least some improvement. I downloaded the latest Vista 32bit driver (186.18) and installed nHancer 2.51, and then configured nHancer properly. The newer nHancer is a little different not allowing you to duplicate FSX as I was used to and I did not see a guide in the forum that went step by step for this version. I know ... normally simple! But for me ... would not duplicate with the familiar "Duplicate" name added. I could create with the same name and "Activate"but nHancer did not apply itself to my graphics and they were noticeably worse than I previously had with stairstepping and a case of the uglys. I ended up going with the driver that came with the 285 (ver 180.87) and to the older nHancer ver 2.32. I spent several hours and I probably missed the obvious, but if I overlooked something simple I would appreciate the feedback.
Jim
Jim