Engines Shut Down On Final

[westside]

I have had this problem on and off for a few months now and last night was the last straw. Long flight only to loose on final approach. I have checked the failures section and nothing is turned on I have even reset the defaults of the failure section. It started with one engine on a dash-8 and now it is all engines. On a twin engine aircraft I have been able to start them back up before crashing but it is impossible to get even two engines back on line in the 747 at 2300 ft and 5 NM out.

[coalpedlar]

Stumps me for sure.
D

[SubZer0]

Is this happening with the default planes or only with addon ones?

[Daube]

You might want to turn ON your carb heat or engine anti-ice

[PingPong]

Do you have a Saitek yolk, the old ones(before new driver installation) were known for sending phantom commands.

[BAW0343]

Did you load enough fuel?

[Excalibur372]

Sorry dude,beats me.

[westside]

The Saitek yoke answer seems to be the most logical. I do have that set up and will disable the Engine Start/Stop command from the yoke side of the controller. That would explain a few other glitches that I have experienced. (Autopilot engaging and engaging and views rotating around on there own. Thanks PingPong

[U4EA]

My (noobie) guess......

POSSIBLY, your throttle is in need of calibration....when you pull off to an extent, you're dropping into an inadvertant engine off situation instead of idle.

Just a guess! :-/