Simviation Forums

A lot of people are complaining about jetways only showing up when some settings are set relatively high.

However, I have just discovered a way around this.

You need the Airport Design Editor (which I believe you need the FSX SDK for).

Open up the airport in question, and then under 'Lists' in the top, choose 'Jetways'.

A list of the jetways in that airport will appear.

Double-click on one, and under 'Image Complexity' set a setting that is either lower than, or matches your autogen density setting.

Compile the airport, place it under Addon Scenery/Scenery, and you're good to go!

BTW, this may not belong here, but I figured it would be relevant to a lot of people, and may not have been noticed a lot, had I placed it in the scenery design forum.

This sounds great  :D
Although,
Alot of people dont want to pay and learn new material.

Probably not, but I've been thinking:

People can come to me with requests for specific airports, for which they want jetways with lower settings, and I'll make it for them

Probably not, but I've been thinking:

People can come to me with requests for specific airports, for which they want jetways with lower settings, and I'll make it for them

Smart..

Good Idea

In that case KDAY, in Dayton Ohio! would be nice if my nearest home airport was a little more functional!

Sending it to ya'

Works fantastic, Thank You!!! 8-)

No problem, I'm here to help

[quote]This sounds great