Page 1 of 1

Frame Rates at Airport!!!

PostPosted: Tue Aug 12, 2008 3:46 pm
by BuzzDatAzz
Hello All,

Does anyone know how to get decent framrates on the ground at the airport and when landing. I get around 7-10 FPS on the ground during taxi and before take-off, then on final approach the FPS drops again.

Please give me some advice on how to get higher frames when on or near the ground.

Thanks in Advance!!!  ;)

Re: Frame Rates at Airport!!!

PostPosted: Tue Aug 12, 2008 5:49 pm
by BAW0343
Sounds like Scenery Density would be your problem. Turn that down in the setting menu.

Also, how high is your setting for airport vehicles? and How big of an airport?

Re: Frame Rates at Airport!!!

PostPosted: Tue Aug 12, 2008 10:09 pm
by BuzzDatAzz
Hey, BAW0343

I will give that a try. I am usually taking off from KPHL or JFK. I am not sure what my scenery density is, I will check it though. Thank You very much for the quick response.!!!

;D

Re: Frame Rates at Airport!!!

PostPosted: Wed Aug 13, 2008 12:04 am
by BAW0343
Yea those are kinda sorta big airports. Not even the high end rigs can go there without it slowing way down.

What are you computer specs anyway?

Re: Frame Rates at Airport!!!

PostPosted: Wed Aug 13, 2008 3:37 am
by Daube
It's not really the airport scenery density.
What is killing the FPS at the airport:
- special animations (animated jetways etc...)
- ground airport vehicules !!
- default Commercial traffic (because of heavy 3D models)
- default GA traffic (same)

Try deactivating the animations, the vehicules and the default GA traffic, and you'll see a huge FPS increase, even with the scenery slider set high. Then switch to some alternative AI commercial traffic, like World of AI, and you'll get another FPS increase.

Re: Frame Rates at Airport!!!

PostPosted: Wed Aug 13, 2008 3:22 pm
by BuzzDatAzz
Here are my Specs:

Vista Home Premium (32bit)
Gateway GT5468
Intel MoBo (DG31PR)
Dual Core Intel 2.33 E6550 1600FSB
4GB A Data PC 2700

Re: Frame Rates at Airport!!!

PostPosted: Wed Aug 13, 2008 9:13 pm
by Orion66
I have a couple of graphic settings saved.  When I'm at the airport, I'll load those settings.  Once I've flown away from the airport, I'll load a different setting.
While at the airport, distance isn't greatly needed, so I'll lower the detail radius.  I'll also have greater aircraft density for a better feel of a busy airport.
Away, from the airport, I'll load a setting that has lower aircraft density, better water, etc.

Re: Frame Rates at Airport!!!

PostPosted: Wed Aug 13, 2008 9:26 pm
by Ferrari308guy
To answer your question:

GA traffic is 'General Aviation' traffic, so this would be the Cessna, Piper, Mooney, Beech, Maul....etc. There is another option (can't remember what it's called..something like 'Commercial Traffic') which would be the airliners.