Simviation Forums

Looking by way of search, there was not a lot of info about this download....Does anyone have issues with it, besides the lengthy ops manual  ;D ?

no, i LOVE the ifly 744  ;D

Are there any patches or updates for the iFly747 ?..I saw in other posts there were, but I can't seem to locate them if there are.

not that I know of

ok....prolly for FS9...trying to work out the "bugs", which are mainly me!

Can't seem to get the EICS screens to light up...plus it seems to want to start the engines, without any prompt. Sort of like the default aircraft when you leave a flight "active" and then start a new one....I'll get through it hopefully! Any suggestions besides the reading the ops manual would be helpful in the interim.... :-?

Thanks!

the enignes will start, you just have to read the WHOLE procedure section of the maual

I've read the procedure section, but I'm stuck at STATUS display switch..Push.

Actually I've been through most of the manual, but I can't seem to get past STATUS, and the go on to set up the CDU and such....

Where is said switch? My eyes are red from staring at the panels, and I just can't find it!  :-[  :-[  :-[   (I know when to give up and ask..)

Unless I'm doing something really wrong!  Which probably is the case!  ::)

[quote]I've read the procedure section, but I'm stuck at STATUS display switch..Push.

Actually I've been through most of the manual, but I can't seem to get past STATUS, and the go on to set up the CDU and such....

Where is said switch? My eyes are red from staring at the panels, and I just can't find it!

I have one issue with it, the 2d panel when you turn on the night lighting is all screwed up. This seems to be the only real problem i have with it, but when i contacted the devs about it, well to be honest, they seemed a bit, well lets just say ignorant.

I have one issue with it, the 2d panel when you turn on the night lighting is all screwed up. This seems to be the only real problem i have with it, but when i contacted the devs about it, well to be honest, they seemed a bit, well lets just say ignorant.

If i recall correctly, the night lighting gets screwed up if you turn it on during the day  ::)  at night, it worked fine for me  ;)

Well...I did get her airborne and back on the ground...which wasn't pretty with out monitoring systems, no screens still....I think I'll download and reload the whole thing again....

So basically I just started engines pushed back, got clearance, took off....

But still no EICS displays.....

Well...I did get her airborne and back on the ground...which wasn't pretty with out monitoring systems, no screens still....I think I'll download and reload the whole thing again....

So basically I just started engines pushed back, got clearance, took off....

But still no EICS displays.....

I have the same problem.

OOOOOOO!!!!!!!!!!!!!!    Make Sure You All Have FSUIPC Installed Correctly. I Had A Guage Problem Until I Intalled It.  :D

OOOOOOO!!!!!!!!!!!!!!    Make Sure You All Have FSUIPC Installed Correctly. I Had A Guage Problem Until I Intalled It.  :D

That may be where it lies....   Thought I did it right....but

I'll let you know how  I make out.

okay