Simviation Forums

On the Airbus A321, there are very nice strobe lights that i like. However, on the CRJ700, the strobe lights are... not too great. Is there a way I can transfer the A321 strobes to the CRJ700 plane? If so, could someone give me specific file names/ whatever I would need to know to do it? Thanks!

below is acopy of the A321 light section from the aircraft.cfg file
just move the highlighted lines into the aircraft.cfg file of the CRJ  8-)
[LIGHTS]        
//Types: 1=beacon, 2=strobe, 3=navigation, 4=cockpit, 5=landing
light.0 = 3, -19.10, -54.15,  5.85, fx_navredm ,
light.1 = 3, -19.10,  54.15,  5.85, fx_navgrem ,
light.2 = 3, -83.60,   0.00,  7.60, fx_navwhih ,
light.3 = 2, -18.60, -53.50,  5.75, fx_strobeh ,
light.4 = 2, -18.60,  53.50,  5.75,fx_strobeh ,
light.5 = 2,   3.70,   0.00, -2.80, fx_beaconb ,
light.6 = 1,  -3.30,   0.00, 11.50, fx_beaconh ,
light.7 = 4,  53.41,   0.00,  4.50, fx_vclighth ,

so you're saying just copy the file that is in red, and paste it into the CRJ 'aircraft.cfg' file?

You need to look in the aircraft cfg file of the CRJ find the same kind of line and replace the FX file with the fx file from the A321 aircraft cfg file. [glow=yellow,2,300]DO NOT COPY THE ENTIRE LINE [/glow] If you do the light might not show up in the correct place  See below

[LIGHTS]
//Types: 1=beacon, 2=strobe, 3=navigation, 4=cockpit, 5=landing
light.0 = 3,  -64.70, -37.00,  -0.50, fx_navredm ,
light.1 = 3,  -64.70,  37.00,  -0.50, fx_navgrem ,
light.2 = 3,  -104.63,   0.00,  14.30, fx_navwhi ,
light.3 = 1,  -29.00,   0.00, -2.30, fx_beaconb ,
light.4 = 2,  -104.63,   0.00,  15.00, fx_strobe ,
light.5 = 1,  -32.50,   0.00,  7.00, fx_beaconh ,
light.6 = 4,  -10.00,   0.00,  3.90, fx_vclighth,
light.7 = 2,  -64.50, -36.50,  -0.50, fx_strobe ,
light.8 = 2,  -64.50,  36.50,  -0.50, fx_strobe ,