How do i
Posted: Wed Sep 05, 2007 8:06 pmIf at all possible take a VC from one plane and put it in the other.
Simviation Forums
Flight Simulator and other chat
https://forums.simviation.com/phpBB3/
How do i
https://forums.simviation.com/phpBB3/viewtopic.php?f=21&t=61365
Page 1 of 1
Posted: Wed Sep 05, 2007 8:06 pmRe: How do i
Posted: Wed Sep 05, 2007 8:09 pmIt's impossible...
Re: How do i
Posted: Wed Sep 05, 2007 8:53 pmIf at all possible take a VC from one plane and put it in the other.
It's possible only with FSX "native" aircraft. Those that have seperate interior and exterior
models. Have a look at some of the default FSX aircraft folders, particularly the "model"
folder. The ones that have two .mdl files included would be the FSX "native" models.
I'm away from home on my traveling laptop so I can't give you any more of a
detailed description of what to look for.
As far as FS9 aircraft, the answer would be "no".
Paul
Re: How do i
Posted: Wed Sep 05, 2007 9:49 pmLike Gypsy_Baron says.. it is possible with planes modeled for FSX. The interior model is seperate from the exterior and "linked" in the model.cfg file.
The only problem is that the reference points can be off. An interior model from a Lear "can" be used for a CRJ, but you'll be sitting pretty far back, relative to the exterior model.. Plus, if there are exterior part visible (like wings), you see the wings from the interior model.. It would look funny to see KingAir wings from the cockpit of Rockwell Commander
The only problem is that the reference points can be off. An interior model from a Lear "can" be used for a CRJ, but you'll be sitting pretty far back, relative to the exterior model.. Plus, if there are exterior part visible (like wings), you see the wings from the interior model.. It would look funny to see KingAir wings from the cockpit of Rockwell Commander
Re: How do i
Posted: Fri Sep 07, 2007 6:29 amok, i'm going to add a question on to here. Say I get a FS9 aircraft with no VC is it possible to add one on by copying the interior model and config lines from a default FSX aircraft?
Re: How do i
Posted: Fri Sep 07, 2007 6:36 amok, i'm going to add a question on to here. Say I get a FS9 aircraft with no VC is it possible to add one on by copying the interior model and config lines from a default FSX aircraft?
No. As already stated this is only possible with aircraft modelled specifically for FSX using the FSX SDK & configured to use a separate VC model
Re: How do i
Posted: Fri Sep 07, 2007 6:43 amThanks Hag, that's what I thought but I was checking just in case. Is it possible to edit the model to the FSX format?
Re: How do i
Posted: Fri Sep 07, 2007 6:45 amI hesitate to say that anything in this hobby is impossible. Whether it's practical is a different matter. I would say not.