Simviation Forums

I added the jetblue embrarer texture yesterday to the default embraer 190 http://www.simviation.com/fs2004jets133.htm When i click on the jetblue plane to fly it in fsx it comes up with the following message "The instruction at "0x20bd4ecf referenced memory at 0x03a221e0. The memory could not be read. Click ok to terminate the program" and closes How do i fix this? Did i upload the texture wrong or what?

I added the jetblue embrarer texture yesterday to the default embraer 190

This is what's confusing me. I wasn't aware that FSX had a default Embraer 190.

If you mean the original FS2002/4 model by J R Lucariny HERE make sure it's installed & working properly before adding new variations. I've downloaded the files & will check them out later.

Right. I figured this one out. It says this in the File ID. You MUST use J R Lucariny's own Jet Blue E190 as a base for this repaint.

The correct base aircraft is posted here. http://www.simviation.com/fs2002jets89.htm

I checked it out in the FSX Demo but didn't bother installing the gauges as they will most likely be incompatible. If you wish to use it you will need a different panel.

This is the J R Lucariny original.


This is the repaint.