I also noticed the flight change issue myself but in RTM. I can take off after landing, I just cant switch planes without the view being messed up and strange load problems. Its always required I exit and reboot the sim to use another plane after a flight has been completed.
I did not explain to clearly. I meant a new flight with a different airplane. I can land and take off ok with the same airplane.
I am flying in XP Pro.
Threaded Optimization is selected and currently set to Auto, will give that a try.
Thats what I meant too... I never could swich aircraft in RTM after landing and have it run right. I always had to close and set up a new flight to change planes.
When it happens, try ALT-ENTER twice to reload the screen and see if it stabilizes. Usually takes a few seconds after it refreshes for frames to go back up.
XP Pro.. Do play with the TO setting in the driver. Being it is not a problem that shows up and you can match a scenery or sim change to the event, I am not sure if its a bug or a thread issue which a config tweak may fix
I do know PTaylor mentions a few things here:
http://blogs.msdn.com/ptaylor/archive/2 ... n-sp1.aspxWhich you might want to review and see if anything pops into mind as it is happening.
With the FSX.cfg now controlling affinity, perhaps adding that to the config may make a difference?
[quote]There is a tweak to control scheduling of threads on cores.
It is not recommended to change these settings unless you have a performance reduction and/or maxed out CPU loads in the PerfMonitor. The tweak is
Edit:Fixed a typo here
[JOBSCHEDULER]
AffinityMask=n
where
n num of cores scheduled
1