FSX Concorde Install
Posted:
Mon Nov 07, 2016 10:00 amby Mossie14
Hi, I am quite new to FSX so the answer to this post is probably very simple. I have successfully installed the FSX Concorde but the last line of the installation instructions says; load at the beginning all 2d panels at least one time to load all xml scripts into the sim. Sorry to say I don't quite understand what I am supposed to do. Everything works OK except none of the switches operate in the cockpit. Help would be appreciated.
Re: FSX Concorde Install
Posted:
Mon Nov 07, 2016 12:39 pmby B0ikat
I think that means go to the 2D panel view and cycle through all 2D panels before using the VC.
Re: FSX Concorde Install
Posted:
Mon Nov 07, 2016 10:28 pmby Andiroto
Hi,
Some xml scripts in different 2d panels work together for the same system like for the reheater, fuel sytem and generated failures (FeMod)!
So its necessary that they will all load into the sim at the beginning of the flight!
The VC is overall not clickable, sometimes from the copilot seat you can click some light switches,but I have the same problem with the original package (at least in my sim)!
Maybe someone can change this . . .
Not important but would restrict a bit the "gameplay" for FEmod panel users of this Concorde package:
Open the "panel.FEMod169/data/Concorde_config" file and replace both already free places at the end of the Lvars section with:
Lvar_98=EGT2WFail
Lvar_99=EGT4WFail
Save it! Have fun!