Runtime Error R6205 Pure Virtual Function Call With 777

[dreamer_toons]

Finally, I was able to fly 777 without the error for the first time after I have adopted the solutions as advised.

In the addition to the steps taken so far as posted by me few days earlier, I have also taken the following steps as advised by the Steam community link shared by Hagar.

Disable the airline traffic density, set to 0%.

Add in the following lines in the fsx.cfg (extracted from http://steamcommunity.com/app/314160/di ... 978584/#p8);

1) Calculate the Affinity Mask with this http://www.gatwick-fsg.org.uk/affinitymask.aspx?SubMenuItem=hardware and add in these lines at the top of the fsx.cfg. 'n' is the calculated
value based on my CPU's cores.
[JOBSCHEDULER]
AffinityMask=n

2) [Display] header:
WideViewAspect=True change this from FALSE to TRUE if you use a wide screen aspect ratio monitor.

3) [GRAPHICS] header:
HIGHMEMFIX=1

No 'discoloration' of the aircraft and error surfaced during my flight so far and I'm monitoring; everything is working as it should.

Many thanks to everyone here for your help and advice.

[Awaken]

Glad you got it it to work! Now it's time to do some flying

[dreamer_toons]

Glad you got it it to work! Now it's time to do some flying

Thanks.

Unfortunately, I install another 777 add on and the error occurred again.

Hence, back tracking and hope all is fine again.

Happy flying, everyone.

[Azframer]

I just found out something about the newer panel that I did not like, it was a huge game changer for me and I have started moving them back to the older version of this panel. I set up for a landing in zero visibility and needed to do a CAT III landing. On make straight in I went through all the motions and when I finally hit Approach Hold and the plane pitched up a ton and banked left hard, GPS was showing at the time I was pretty lined up. The Boeing 777-200 or the 300 are the only plane that I have been able to do a CAT III landing with.

but that is me
Rick