Page 1 of 1
Can't fly into Beijing airspace
Posted:
Thu Jan 24, 2013 6:54 pmby AirAmerica
I can't seam to approach Beijing (ZBAA) without FS9 crashing. Sometimes I can start FS9 at ZBAA and it will run for a few minutes, then crash. I've tried changing time of day thinking an add-on a/c is the problem. I've changed to a default FS9 a/c with the same results. I tried reducing the terrain complexity and mesh with no luck.
Re: Can't fly into Beijing airspace
Posted:
Sun Jan 27, 2013 3:25 pmby Webb
It could be a bad .bgl file.
Unfortunately I don't know how you could detect or repair this in FS04. There is a BGL scanner that was made for FS02 but I don't know if it works with FS04.
Re: Can't fly into Beijing airspace
Posted:
Tue Jan 29, 2013 5:27 pmby EVVFCX
Hi
you could use the afcad for fs9 and open that airport,from memory it gives the bgl file being used for the original,
Area flies OK on mine.
Normally I could look this up for you but the pc the airport designer is on is out of use at the moment.
regards
steve
Re: Can't fly into Beijing airspace
Posted:
Tue Jan 29, 2013 5:44 pmby c130lover
Sounds like a political problem to me. Try negotiating a trade agreement with Beijing.