Can't fly into Beijing airspace

[AirAmerica]

I can't seam to approach Beijing (ZBAA) without FS9 crashing. Sometimes I can start FS9 at ZBAA and it will run for a few minutes, then crash. I've tried changing time of day thinking an add-on a/c is the problem. I've changed to a default FS9 a/c with the same results. I tried reducing the terrain complexity and mesh with no luck.

[Webb]

It could be a bad .bgl file.

Unfortunately I don't know how you could detect or repair this in FS04.  There is a BGL scanner that was  made for FS02 but I don't know if it works with FS04.

[EVVFCX]

Hi
you could use the afcad for fs9 and open that airport,from memory it gives the bgl file being used for the original,

Area flies OK on mine.

Normally I could look this up for you but the pc the airport designer is on is out of use at the moment.

regards

steve

[c130lover]

Sounds like a political problem to me. Try negotiating a trade agreement with Beijing.