Page 1 of 1
What the heck is this now?
Posted:
Fri Nov 20, 2009 11:05 pmby stevehookem
Just when we think all is fine, now this is happening!
What is going on here? The temp on the GPU is 46 under load.
Re: What the heck is this now?
Posted:
Sat Nov 21, 2009 12:05 amby Crashwoody
I used to have a graphic card that when it over heated it did that.
Are you over clocked in any way? I found that I had a lot of dust and it was causing my machine to over heat.
Sorry to see that. :-/
Tom
Re: What the heck is this now?
Posted:
Sat Nov 21, 2009 5:26 amby JBaymore
maybe clean out your air ducts on the graphics card. I have to do that somewhat frequently. The passages are quite small and they accumulate stuff rather quickly. It requires some dis-assembly of the card....at least for me. And a soft brush, and a bottle of compressed air. Do it outside........ dusty/ messy.
best,
...................john
Re: What the heck is this now?
Posted:
Sat Nov 21, 2009 8:24 amby stevehookem
I was looking at the temp under load and it was 46
Re: What the heck is this now?
Posted:
Sat Nov 21, 2009 9:54 amby jwenham
[quote]I was looking at the temp under load and it was 46
Re: What the heck is this now?
Posted:
Sat Nov 21, 2009 5:18 pmby stevehookem
No bufferpool setting.
I stopped using nHancer to see if I could get my multi-monitor setup to work again. It was letting me pull it over without crashing.
I'm wondering if this has something to do with the NVidia control panel. I'm not sure how to set it up to work correctly. Do I turn on anti aliasing in the game now?
Re: What the heck is this now?
Posted:
Sat Nov 21, 2009 7:05 pmby jwenham
No bufferpool setting.
I stopped using nHancer to see if I could get my multi-monitor setup to work again. It was letting me pull it over without crashing.
I'm wondering if this has something to do with the NVidia control panel. I'm not sure how to set it up to work correctly. Do I turn on anti aliasing in the game now?
OK, sounds like the driver became corupt on you. Un-install Nhancer, un-install your vc driver, then boot in safe mode and run driver sweeper, and re-install your driver. I dont have fs9 so Im not sure how to tell you to turn it on in game. You should be able to set it thru the nvidia CP I think. SO are you saying that WITHOUT Nhancer you can move things around without crashing?
Re: What the heck is this now?
Posted:
Sat Nov 21, 2009 7:34 pmby Crashwoody
Well you could be using a frequency that the mother board is not happy with. Or a program running in the back ground that you don't know about is.
Use "EndItall" then run the sim again and see what happens.
http://www.docsdownloads.com/enditall-1.htmTom
Re: What the heck is this now?
Posted:
Sun Nov 22, 2009 12:51 amby wdavis
Do you have the latest drivers for your card?
Re: What the heck is this now?
Posted:
Sun Nov 22, 2009 2:34 amby garryrussell
Might be worth lifting your card and reseating in case it's worked loose and not making full contct.