Simviation Forums

Well it all started this morning when I wanted to do a nice flight from Seattle to Las Angeles..

I am having a problem with the ATC... When I start on ground atc everything starts to doulbe itself! Here is a picture of what I am talking about



When I tune to tower I am not only getting tower but ground as well! Then when I tune to departure. I am getting ground, tower, and departure!!! WTF? Everything was working fine yesterday and now it isnt....

Plus when I went to "End Flight" The flight just reset it self! WTF?


Anybody have this problem before?

I really dont want to re-install considering that I have a whole bunch of add-on sen.

Im sad...

Did it happen again the next time you loaded up the Sim..?

(I'm assuming the fault corrected itself then?).....!

Paul...G-BPLF...FS 2004....FS Navigator... 8-)...!

Did it happen again the next time you loaded up the Sim..?

(I'm assuming the fault corrected itself then?).....!

Paul...G-BPLF...FS 2004....FS Navigator... 8-)...!

Yes it did..... TY

Did it happen again the next time you loaded up the Sim..?

(I'm assuming the fault corrected itself then?).....!

Paul...G-BPLF...FS 2004....FS Navigator... 8-)...!

Yes it did..... TY

What.... ....

Happened again?....or corrected itself?

Paul...G-BPLF... 8-)..!

If FS9 has a main CFG file, you could rename it and let the sim write a new one.

Probably not helpful - becasue I can see Seattle Approach on your screenshot - but sometimes smaller airports have the same frequency for ground/tower/aprpoach.

I'm guessing Seattle isn't a smaller airport though
Stew

I have had the same problem when around Washington DC like National and BWI. If I end flight it resets and I just quit program. But I did notice that the some of the problems started with certain DLed planes I will not mentioned them as of yet until my testing is complete. But one thing i did do was rename the FS config file and it started right up just fine