not again

[olderndirt]

Hagar
Take a look at this one.

[olderndirt]

Oops.  Forgot to mention FS2004/jets/early files/page 2.

[Hagar]

First you need to identify the correct Panel folder to install to your F-16. This appears to be the one shown open in your shot. Right-click on it & select Cut. Then go up two levels into the main Thunder folder & paste it in. Overwrite files/folders when prompted.

If I remember correctly you then have to paste the Panel.cfg included with the F-16 into the new Panel folder. This should give you the VC gauges. If you tell me where to download the aircraft I'll check it out for you. I should already have the panel.

[quote]Oops.

[Groundbound1]

Yup. The sim will only recognize the contents "outer-most" panel folder.

So, in other words, in this example:
...F-16/ panel/panel.cfg,

[olderndirt]

Nice panel - no gauges.  Makes for an interesting approach and landing.  Need lots of runway.  All this back and forthing between folders and FS - gotta be a shorter way.

[Hagar]

It's the way the files are configured. Some are better than others. Nothing anyone can do about that I'm afraid.

Make sure you installed the gauges included with the panel.

[Groundbound1]

Sorry guys, I wasn't trying to be a "buttinski", just dropping my two cents into the bucket.

[olderndirt]

By no means.  Thus far, Hagar has been my 'good samaritan' but I can use any and all the help I can get.

[Hagar]

[quote]By no means.