Simviation Forums

When I land and the tower prompts me to turn next taxiway or to vacate runway when able, I find that it's a little too impatient in doing so. I keep a reasonable pace and go for the next taxiway, but still the tower prompts me at least twice, which is a bit annoying. Is there a way to increase the interval between those calls?

When I land and the tower prompts me to turn next taxiway or to vacate runway when able, I find that it's a little too impatient in doing so. I keep a reasonable pace and go for the next taxiway, but still the tower prompts me at least twice, which is a bit annoying. Is there a way to increase the interval between those calls?

Yes.
Turn off the radio.


I have found that in FS9 as in real life, some controllers are more patient than others... and of course in both cases it may depend on other traffic.

I can't advise you on editing the AI ATC program, but maybe you just have a lot of traffic behind you or waiting to take off when this happens?

I say...

"Give it some gas Grandma!"  ;)

It's just easier to hustle off the runway. maybe let the aircraft roll at 70 knots or so for a few seconds, then hit the breaks again when you get close to a taxiway. Not that realistic, but it works.

Yup, i usualy let her roll out on 40 IAS then down too 20 too take the first taxiway.

I used to do 50KIAS...I'd usually choose taxiway's that were longer than others...I also set the AI to roll out at 35KIAS...

If you use Editvoicepack it eliminates the "Vacate Runway" instruction
Vololiberista

If you use Editvoicepack it eliminates the "Vacate Runway" instruction
Vololiberista

WRONG! I use editvoicepack and it still will tells you to vacate the runway 8-)

Under ICAO settings it does
Vooliberista

maybe you just have a lot of traffic behind you or waiting to take off when this happens?

It does this regardless of the amount of both types of traffic.