Page 1 of 1
Bad Bravo by By Geoffrey M Biteman Problem
Posted:
Thu Oct 18, 2007 8:51 amby FS_Pilot
I am unable to get the Bad Bravo which i just downloaded from the Simviation library to move along the runway there is a problem i think within the aircrat.cfg. After starting the engine and appying throttle i get a slight movement from the Manafold pressure gauge then it drops back to zero again. Any ideas please? or if the creater could contact me via PM.
Thanks FS_Pilot
Re: Bad Bravo by By Geoffrey M Biteman Problem
Posted:
Thu Oct 18, 2007 11:04 amby commoner
...mm... again I have to ask the question....give us the EXACT file name and then we can help........commoner
Re: Bad Bravo by By Geoffrey M Biteman Problem
Posted:
Thu Oct 18, 2007 11:19 amby FS_Pilot
The file is BadBravo.zip and it can be found at
ftp://www.simviation.com/47props/BadBravo.zipFS_Pilot
Re: Bad Bravo by By Geoffrey M Biteman Problem
Posted:
Thu Oct 18, 2007 12:15 pmby gwillmot
Same here.....I noticed that advancing the throttle shows no engine rpm on gauge. Fuel consumption goes up. No aircraft movement.
gwillmot
Re: Bad Bravo by By Geoffrey M Biteman Problem
Posted:
Thu Oct 18, 2007 12:28 pmby dave3cu
Aircraft.cfg file error(s)
[piston_engine]
power_scalar = 1.0
Re: Bad Bravo by By Geoffrey M Biteman Problem
Posted:
Fri Oct 19, 2007 2:46 amby FS_Pilot
Thanks dave3cu, That fixed the problem.
Thanks FS_Pilot
Re: Bad Bravo by By Geoffrey M Biteman Problem
Posted:
Fri Oct 19, 2007 9:30 amby krigl
[quote]Aircraft.cfg file error(s)
[piston_engine]
power_scalar = 1.0
Re: Bad Bravo by By Geoffrey M Biteman Problem
Posted:
Fri Oct 19, 2007 9:34 amby Zaphod
[quote][quote]Aircraft.cfg file error(s)
[piston_engine]
power_scalar = 1.0
Re: Bad Bravo by By Geoffrey M Biteman Problem
Posted:
Fri Oct 19, 2007 9:44 amby FS_Pilot
There is one thing i would like to see Simviation or any other site for that matter to do before allowing files tp be uploaded and posted and that is to make sure there is a valid & verified email address of the poster included in the file so people can contact them if there is a problem. There was no email address included with this file. This is the reason for the post as i was unable to contact the poster to sort out the fault.
I would like to thank all of you for your help in getting the problem solved. FS_Pilot