Page 1 of 1
Why does it do this!!!!!!!!!!!

Posted:
Mon Aug 13, 2007 12:28 pm
by Domino5
Whenever I fly my default learjet on FS2004, during takeoff it just goes to the right. It just drives off to the right. the same when I land. Does this happen because of an addon I have?
Re: Why does it do this!!!!!!!!!!!

Posted:
Mon Aug 13, 2007 12:36 pm
by Sir_Crashalot
Is your rudder centered when your on the ground or is it turned to the right?
Crash

Re: Why does it do this!!!!!!!!!!!

Posted:
Mon Aug 13, 2007 12:50 pm
by Domino5
Is your rudder centered when your on the ground or is it turned to the right?
Crash

It's centered, everything looks normal but it turns. Even in the air it turns!!!!!!!!!!!
Re: Why does it do this!!!!!!!!!!!

Posted:
Mon Aug 13, 2007 12:58 pm
by Crussell
Only happens to me if I start on the runway, if I start at the gate it's fine.
Try letting your engines warm up.
Re: Why does it do this!!!!!!!!!!!

Posted:
Mon Aug 13, 2007 1:09 pm
by Sir_Crashalot
Ok. Check if both jet engines respond to your throttle input. If you apply full throttle do both engines also go to their max power or only the left one? Check your dials on the panel to see this.
Crash

Re: Why does it do this!!!!!!!!!!!

Posted:
Mon Aug 13, 2007 2:06 pm
by Nick N
delete the FS9 default flight, let FS9 make a new one and try it again
I have seen this happen with FS9 and FSX. Something about a different flight along the way gets saved and when the sim is booted and not started cold and dark it displays this.
I have also seen real world weather elements saved from another flight in the way of cross winds cause a pull to the right or left
Not saying this is the problem but assuming the controls are being flown correctly, its possible.
Re: Why does it do this!!!!!!!!!!!

Posted:
Mon Aug 13, 2007 2:19 pm
by born_2_fly
Wind? ::)
Re: Why does it do this!!!!!!!!!!!

Posted:
Mon Aug 13, 2007 5:28 pm
by Nick N
[quote]Wind?
Re: Why does it do this!!!!!!!!!!!

Posted:
Tue Aug 14, 2007 1:52 am
by commoner
...mm...think I have seen this happen when using a flight which was saved with the AP inadvertently left switched on ...not sure about that but just try switching the AP on then OFF again to make sure......commoner
