Simviation Forums

I downloaded the A330 from simV found on http://www.simviation.com/fs2004jets16.htm
i put the gauges in the gauges folder but the altitude indicator dosn'e work it just stays in one screen. also the EICAS wount work too. what is the problem? :-?

Were they .cab files? If so, did you unzip them?

Also, sometimes, If gauges come inside a folder, you are expected to put that folder into the main gauges folder  ;)

I just dowloaded this package and what you need to do is open the gauge folder and move everything there into the FS gauge folder or the air craft panel folder [glow=yellow,2,300]DO NOT OPEN THE FOLDER WITHIN THE GAUGE FOLDER LEAVE IT INTACT AND COPY OVER[/glow] Gauges inside of this subfolder are a prime example of a .CAB file 8-)

I downloaded it earlier & 2 gauges appear to be missing. I can only suppose these were left out of the package.

Do you know the file names of the missing gauges? If so, you might be able to find them somwhere else. If not, is the panel available in other POSKY packages? You could use the gauges from another package. God luck!

The missing gauges are named FPDA_A330_Callout & Toggles.

I also found this. http://forum.projectopensky.com/index.php?showtopic=24591&pid=220837&st=0&#entry220837

I say replace the panel. http://www.simviation.com/cgi-bin/perlf ... a330+panel

http://www.simviation.com/fs2004panels20.htm
this is a good photoreal panel