Hmmmmmm....
Strange, no crashes here....
In lookiing over the issue.,. I do believe you MUST have the ATI official CCC Cat 5.9 or higher driver installed or the latest release of the Omega drivers
I found the best setting for FORCE MSAA was 4 on my system however you can change that back to 0 if you want. The only setting that must to be active is:
ForceAlphaToCoverage = 1
but as I said, it works better for me if ForceMSAAMode = 4 is set.
Sorry if it is not working for you...
This fix is for the shimmering and flickering trees, leaves and foliage ...and clarity of the overall image... it is not a fix for the buildings.
This fix was posted at AVSIM and a few other sites and it does work for me (ATI x800 AIW @ 540core - 585mem. It cuts down significantly the flicker from the AG trees, which I run AG @ 100% I run 4AA and 16AF with vertical refresh on.
... and as a side note, I understand the latest version of ATI Tray tools by ray adams
http://www.guru3d.com/article/atitraytools/189/ allows you to enable ADAPTIVE AA as long as you have the CAT 5.9 or higher driver installed. You do not need the DX Override fix if you use Ray Adams tray tools enable A-AA feature. I am going to test this on my system and will post back results
Dont expect every tiny flicker to go away... HOWEVER
....I run FS9 with very high quality settings and the tree and ground flickers even at a mip detail setting of 4 has always been annoying as hell.. until now!!!
Last edited by NicksFXHouse on Fri Feb 10, 2006 12:50 pm, edited 1 time in total.
"In theory, there is no difference between theory and practice. But, in practice, there is."
....
...!
...!
...
