Page 1 of 1

ATR virtual cockpitt

PostPosted: Fri May 20, 2005 3:10 pm
by twistedsucker
Does anyone know where i can get a decent freeware ATR virtual cockpit

Re: ATR virtual cockpitt

PostPosted: Fri May 20, 2005 3:19 pm
by GA_Pilot
Check the downloads section here at SimV, either under panels or props, I just downloaded one here a few days ago  ;D

Re: ATR virtual cockpitt

PostPosted: Fri May 20, 2005 7:42 pm
by dave3cu
Generally, VC's are not downloadable as they are part of the a/c's '*.mdl' file.

The exception would be if someone did a total upgrade to an a/c, which now displays a V/C.

Dave

Re: ATR virtual cockpitt

PostPosted: Sat May 21, 2005 3:06 am
by Hai Perso Coyone?
There is a whole aircraft package by Francisco Sanchez Castaner. It has a VC and Cabin!

Cheers,
Ashar ;)

Re: ATR virtual cockpitt

PostPosted: Sat May 21, 2005 3:43 am
by twistedsucker
There is a whole aircraft package by Francisco Sanchez Castaner. It has a VC and Cabin!

Cheers,
Ashar ;)



can you please give me a link to this aircraft? :)

Re: ATR virtual cockpitt

PostPosted: Sat May 21, 2005 5:52 am
by RollerBall
Regrettably, you'll find that the ATR panel/VC is a problem in FS2004, unless you find a version the rest of us haven't.

Look at the following

http://www.simviation.com/cgi-bin/yabb/ ... 477;start=

I'm afraid I've not had the time to upload my version yet which has matching panel and VC and a nice overhead which is useable in flight (the one that comes with the plane is very elaborate but it takes up the whole screen so you can only use it on the ground). I think Fly-In's update using the Kingair gauges has been.

The 'small' ATR doesn't have a virtual cabin but the 'big' one does. I think that's the 500 but I can't remember the model. The version I have is the Iberia Regional. Very nice

Re: ATR virtual cockpitt

PostPosted: Sat May 21, 2005 12:33 pm
by twistedsucker
Ok, thanks for your help!

Re: ATR virtual cockpitt

PostPosted: Sat May 21, 2005 12:52 pm
by RollerBall
The reason all this panel re-working was necessary was because some gauges didn't show properly on the panel and also, because of a gauge conflict, HDG and CRS only changed in multiples of 10 degrees (rather than 1 deg) and ALT only in 1000s (not 100s) of feet.

Here's where I'm at with my panel.

Image

Image

Image

Nearly there. Want to get the proper surrounds round the ADI and HSI in the VC though

And here's the version that I fly with the VC and cabin

Image