Simviation Forums

hey guys i just need your help again guys plzz . i wanted to know in what section in the cfg file. where i can change the sensitivity of the trim settingstrim settings and drag setting were i can make the plane slow down without putting the throotle on idle. coz i got problems with the sga dc-9 especially on landing even i overload the plane...

one more thing. where can i get a better
747-400 manual
a320 manual
and also a 777 manual?

thnx in advance!! i hope i can get a reply

Hello rajiv2,
Click on the FS2004 FAQs which is located at the top of the FS2004 Forum.

The first topic is "How to locate your FS9 config file".

Hope this helps!!

Dave

If you are looking to fine tune flight characteristics of a specific acft. then look in the acft.cfg down in the "flight tuning" section. ( Think that is what it is called....not at home and trying to rem. off the top of my head

sir i got the air ed sir
if i minus the number in big number will that would be good idea? or increase the number in big number
ex. 7833 and 10000?

For a helpful guide in 'tuning' your aircraft, a good reference is the FS2004 Aircraft Container SDK', available here.http://www.microsoft.com/games/flightsimulator/fs2004_downloads_sdk.asp#aircraftcontainer

It explains each section and parameter in the aircraft.cfg file.

Dave

i dont know about air ed, but fsedit does have a tuning section, and there you can increase the drag...

you can download it in the microsoft SDK page...

i think its the FSedit SDK or something like that

Use AirED to edit line 1101 (primary dynamics) in the .air file, specifically the skin friction coefficient value. Increase the negative number to increase the drag, slowing the plane when you reduce thrust. This also affects things like range, but that can be adjusted in the aircraft.cfg.

As always, back the original file up first in case of error.

thnx for your help guys
now im trying to learn the aircraft cfg file right now