Page 1 of 1
Question about a parameter
Posted:
Sat Dec 11, 2004 6:06 pmby jordonj
I just installed the Victoria Falls scenery (for reasons that will be obvious...hee hee)
The thing is, I had to edit a line in FSconfig.
TERRAIN_MAX_VERTEX_LEVEL=20
What does that control? Will it adversely affect my scenery...or is a higher number better?
Re: Question about a parameter
Posted:
Sat Dec 11, 2004 7:03 pmby eno
That number defines the resolution of the terrain mesh.
The higher the number the higher the resoulution that can be shown.
I think thats right ....... I'm sure I'll be corrected if not.
Re: Question about a parameter
Posted:
Sun Dec 12, 2004 9:50 amby jordonj
Well, I just noticed that my simulator has taken a performance hit! I'm going to change it back and see if that was the cause of it...
Re: Question about a parameter
Posted:
Sun Dec 12, 2004 10:06 amby commoner
..guess you are right there eno...mine has been at 19 since the patch.....never tried changing it though but I can see that performance might suffer with higher numbers....commoner
Re: Question about a parameter
Posted:
Sun Dec 12, 2004 10:36 amby jordonj
Well, I changed it back but performance didn't improve...
I'll have to try something else...